Team Xecuter Liteon DG-16D4S - Unlocked Replacement PCB

Do you have a faulty Liteon DG-16D4S DVD in your Xbox 360 ?

Are you swapping your drive to another console and are unable to program your firmware due to write protection being enabled?

Team Xecuter have done it again with this custom made replacement PCB. Fits all DG-16D4S drive versions and allows you to reprogram your firmware to the board and then to set it to write protect to secure against any accidental firmware corruption / erasing.

• Fits all Liteon DG-16D4S Drives
• Fully compatible with 9504, 0225 and 0401 fw revisions
• Write Protect enable / disable feature
• Simply swap out the old board with your new board and you are good to go !
• Easily programmable using the X360USB PRO or compatible SATA.

Additional Information:
We should reiterate that this is not a simple copy of the DG-16D4S board, but a custom made version with a new chipset (and not just a single IC change), and it will be completely solderless - the install will simply be a cut and clip design. 

Also note that if you are using a 9504 drive (if you are lucky enough to find a non-fake version) that the drive's MT controller can be locked at ANY time via cdb commands. This is non reversible and is not a scare tactic, it is a fact. The custom DG-16D4S PCB has a manual write protect enable / disable switch so YOU are in control. You simply disable WP, Flash the drive, Enable WP and you are done.  We have tested the board on 9504, 0225 and 0401 consoles and they are working perfectly - all on Live with no problems whatsoever.

Note: All replacement boards are shipped blank. You must program your consoles correct firmware version and drive key.

Stock Status: In Stock